Laying on sand or gravel

The slabs can be laid dry by simply placing them in the desired position, without the need adhesives. This means the slabs are easily levelled out on top of the sand/gravel and are ready for use immediately afterwards. This allows users to change the paving at any time or reuse the same material several times, even in different locations. It is recommended to lay with a 2% slope to avoid water accumulation.




DRIVE-OVER

Drive-over for slabs with 3 and 6 cm (1.2" and 2.4") thickness

Installation

Example of laying on ground

  • A) Slabs with Cross Spacer
  • B) Sand/Gravel
  • C) Non-woven fabric
  • D) Drainage layer
  • E) Soil

Example of laying on ground

  • A) Slabs with Cross Spacer
  • B) Ballast layer of sand/gravel
  • C) Separation layer
  • D) Thermal insulation element
  • E) Vapour barrier
  • F) Waterproof layer
  • G) Sloping screed
  • H) Floor

The proposed diagrams and indications are purely indicative of the type of application: please refer to the specific regulations in force in your country in order to lay the floor to the highest technical standards. It is recommended to lay with a 2% slope to avoid water accumulation.


ADVANTAGES

  • Easy to install
  • Draining surface
  • Easy maintenance
  • Inspectable

DESTINATIONS

  • Driveways
  • Garden, courtyard or patio
  • Residential areas
  • Commercial areas
  • Terraces

Instructions:


What you need:

Slabs


Level


Sand or gravel


Cement


Adhesive


Rubber mallet


Vibro compactor


Cross spacers


Laying

Example of laying on ground of STONE GRES Pavè

  • A) Pavè
  • B) Sand or gravel
  • C) Screed with electrowelded mesh
  • D) Roadbed
  • E) Soil

The proposed diagrams and indications are purely indicative of the type of application: please refer to the specific regulations in force in your country in order to lay the floor to the highest technical standards. It is recommended to lay with a 2% slope to avoid water accumulation.


Instructions: